How To Use This Manual; Included In The Box; Required For Installation - Heatworks 1X Manual Del Usuario

2

HOW TO USE THIS MANUAL

Please proceed with installation of your MODEL 1X by
following the steps in the sequence they are presented.
Throughout this manual, we have highlighted certain
points that require special attention. These points are
indicated by the three BOLDED categories below:
"IMPORTANT" Commonly missed step in installation.
"CAUTION" Negligence of this step could result in
damage to your MODEL 1X or personal injury.
"HEATWORKS RECOMMENDS" The user or installer
should be aware of these additional notes and benefits.

INCLUDED IN THE BOX:

1 Heatworks MODEL 1X water heater
1 Heatworks MODEL 1X Installation and User Manual
2 Mounting Brackets
4 Mounting Bracket Screws
2 Zip Ties
3 Ferrules
Tie Wrap
Tank Power Wire Extension
CAUTION: Breaker must remain off until installation is complete.
2

REQUIRED FOR INSTALLATION

Ferrule Crimper Tool
Designated 110-250 volts, 15-48 amp circuit installed
by a licensed electrician.
Water supply using ¾" or 22mm push-fit connectors
Flat mounting surface (ie: a wall) – DO NOT SECURE
THE MODEL 1X TO PIPING
RECOMMENDED FOR INSTALLATION
Flexible water heater connection hoses
ADDITIONAL HELPFUL MATERIALS
Drywall anchors, plywood, or stud finder to ensure
brackets will support the MODEL 1X
Level to ensure mounting brackets are level before
MODEL 1X is secured with zip ties
YOU ARE NOW READY TO BEGIN INSTALLING YOUR
HEATWORKS MODEL 1X
Please continue to page 3
www.myheatworks.com