Installing The Mounting Brackets - Heatworks 1X Manual Del Usuario

4

INSTALLING THE MOUNTING BRACKETS

IMPORTANT: The Heatworks MODEL 1X must be
oriented horizontally.
The water inlet must be on the bottom of the MODEL 1X,
and the outlet must be on the top. (Shown in Heatworks
MODEL 1X Diagram; page 3)
Do not use any other mounting method than the
brackets and zip ties provided.
STEPS
1) Position (2) mounting brackets approximately 6 - 8
inches apart and level to support the weight of the
MODEL 1X, which is approximately 15 pounds when full
of water.
HEATWORKS RECOMMENDS:
strongly recommended for installation, or drill directly
into studs. Do not attach to drywall without drywall
anchors.
2) Secure mounting brackets to a flat, vertical surface,
such as a wall, using mounting (4) bracket screws.
3) Place the MODEL 1X on the brackets. Check the
position and orientation to ensure the unit is level, with
the inlet on the bottom and the outlet on the top.
4) Thread (2) cable ties through the brackets, around the
MODEL 1X.
CAUTION: Breaker must remain off until installation is complete.
4
Dry wall anchors are
YOU ARE NOW READY TO PROCEED TO ELECTRICAL
INSTALLATION
Please continue to page 5
www.myheatworks.com