Use; Steam Cleaning - Dirt Devil AquaClean M317 Manual De Instrucciones

M317.book Seite 45 Montag, 30. September 2013 1:40 13

4 Use

4.1 Steam cleaning

4 Use
WARNING:
Danger of scalding when using the appli-
ance!
 Never direct the steam jet at persons,
animals or plants.
Always point the steam jet downwards

towards the surface to be cleaned. Even
then, take care that parts of your body never
get into the steam jet.
 Never use your hand to test whether
steam is coming out!
Never lay the appliance on its side dur-

ing operation.
A
D
E
G
19
1. Check that the water tank is full. If not, fill
it (Chapter 3.5, "Filling the water tank").
2. Insert the mains plug into a socket with
ground/safety contact (Fig. 19/A).
- The steam ready indicator is illuminated
red (Fig. 19/B).
- The appliance will now heat up.
3. Wait about 3–4 minutes (Fig. 19/C) until
the pin in the water tank cap goes up
(Fig. 19/D) and the steam ready indicator
changes from red to green (Fig. 19/E).
Your appliance is now ready for steam
cleaning.
NOTE:
B
The time until your appliance has built up
steam can vary according to the water tem-
perature and quantity in the water tank.
4. Now, you can push the steam button
(Fig. 19/F).
- A few drops of water will be ejected first.
Collect these if you want to avoid pud-
dles.
C
- After a short while, a steam jet will ap-
pear (Fig. 19/G).
- The steam flow will stop as soon as you
release the steam button.
ATTENTION:
Do not operate the appliance on one spot
for a prolonged time. Keep moving the
F
appliance back and forth to loosen dirt on a
larger area. Otherwise there is danger of
damaging the surface to be cleaned.
NOTE:
If the steam ready indicator changes from
green to red, you can continue to work.
Only if the steam produced is no longer suf-
ficient, should you release the steam button
and wait so the device can reaccumulate
pressure and produce steam again.
45