Cable Installation - npg NLD227B-P Manual De Usuario

Introduction

Cable Installation

- Before the installation and use, please read carefully the relevant content in "Notice
for Maintenance and Safety".
1.Take the LED TV from the wrapping package and put it in a drafty and LED place.
Notice:
When you plug or unpluy the LED TV,computer or other equipments, you must make
sure that the AC power has been already shut down; when unplugging the power
cable or signal cable, please hold the plug(the insulated part), do not draw the body
of the cable.
2.The RF output terminal can be connected with the RF input port of the TV.
3.The output AV terminal of DVD can be connected with the AV input port of the TV
through AV cable.
4.Connect one end of the VGA cable with the VGA port on computer, connect the other
end of the VGA cable with the VGA port on the TV, and tighten the bolts clockwise on
the each end of VGA cable.
Notice:
While connecting the 15-pin VGA, please do not insert the plug overexertedly, for
fear the pin might be broken.
5.Connect one end of the HDMI cable with HDMI output port, connect the other end of
the HDMI cable with the HDMI port on the TV.
Notice:
While connecting the HDMI,please aim at carefully,do not insert overexertedly, for
fear the pin might be broken.
6.Check and make sure that all AV cables are connected with the corresponding ports
correctly.
7.Connect the AC power cable with 100-240V~ power supply.
8.Connect the other end of the AC power cable with the AC power port on the TV.
Caution:The range of power input for the LED TV is 100-240V~ 50/60Hz, do not
connect the TV power input port with the AC power out of the above range.
Please hold the insulated part of the plug when you are unplugging the power cable, do
not touch directly the metallic part of the cable.
7