Adjusting Pdu Mounting Brackets - Tripp-Lite SmartRack 2400 Serie Manual Del Usuario

Enclosure Configuration

Adjusting PDU Mounting Brackets

WARNING: Do not attempt to adjust brackets without assistance. Do not attempt to adjust brackets while equipment is installed in the enclosure.
Do not attempt to use brackets without screws installed (2 per bracket).
The 4 PDU mounting brackets are pre-installed with the rack enclosure. Do not adjust the mounting brackets unless your equipment requires a different
mounting depth. The sets of brackets can be adjusted independently in ¼-inch (6 mm) increments.
1
Each bracket is connected to the enclosure with 2 screws – 1 pair at the upper beam
the lower beam B .
2 Remove the screws fastening each of the PDU mounting brackets to the enclosure.
3 Slide the PDU mounting brackets to the desired depth and reattach them using the screws you
removed in Step 2. The attachment points are numbered
the same depth.
A
and 1 pair at
A to help you align each pair of brackets at
11
A
B
1
2
A
3