Countertop Requirements; Installation Procedure; Prepare Installation Space; Install Appliance - Gaggenau VG 264 CA Instrucciones De Instalación

Countertop Requirements

,
WARNING:
To reduce the risk of ignition of
surrounding combustible materials, install at
least 6" (150 mm) from both sidewalls and at
least 2" (50 mm) from the rear wall.
The countertop must be level and horizontal. The
stability of the countertop must be maintained after
the cut-out has been made.
¡
 PP
ƒ


 PP
PLQ   PP


  PP
PLQ   PP

Technical Data

Total connected load electric: 0.8 VA
Gas
Pressure
A-burner full burn
A-burner low burn
B-burner full burn
B-burner low burn
Total connected load
Total consumption
6
[
¡
 PP
PLQ   PP
PLQ 
 PP
PLQ   PP
Natural Gas LPG (Propane)
Type N Type X
6" water 10" water
column column
(1.5 kPa) (2.5 kPa)
94 74
49 36
128 87
58 42
32 000 BTU 32 000 BTU
(9.4 kW) (9.4 kW)
0.9 m³/h 680 g/h

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection
strip between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1

(40 mm).

Install Appliance

,
WARNING:
or turn on power supply, make sure all controls
are in the OFF position.
1
Make a mark exactly in the center of the cut-out.
Fasten the mounting rails to the front and rear
edge of the cut-out. The leading edges of the
mounting rails must lie upon the worktop. The
center marking of the mounting rails must
correspond precisely with the center marking of
the cut-out.
Note:
For natural stone worktops, adhere the
mounting rails with temperature-resistant duel-
component adhesive (metal on stone).
3
/ " (10 mm).
8
Before you plug in an electrical cord
Take into
9 / "
16