Field Of Application - WAGNER CONTROL PRO 350 M Instrucciones De Funcionamiento Originales

Control Pro 350 M
1 Hose holder
3 Telescopic handle
5 Pressure regulator with integrated ON/OFF switch
7 Selector switch
9 Suction hose
11 Inlet filter
13 High-pressure hose
15 Nozzle 517 (for thick materials, e.g. interior wall paints)
17 HEA Filter Set
19 Nozzle 311 (for thin materials, e.g. lacquers)
* pre-installed in the filter housing
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,
base coats, fillers and anti-rust paints.
Another nozzle size and gun filter must be used, depending on the material to be processed.
i
Thin materials:
Thick materials:
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials, materials containing acetone or cellulose thinner
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
i
contact Wagner Service in cases of doubt.

Field of application

Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
•
Wrench (13, 16, 17, 20) and/or adjustable wrench (2 pcs.) and hex key (10 mm)
•
Hex key (2.5 mm)
•
Empty container
•
A large piece of cardboard
•
Covering material
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
Danger
covered.
Pay attention to the quality of the adhesive tape used. Do not use excessively strong adhesive tape on wallpaper and
i
painted surfaces, in order to avoid damaging these surfaces when removing the tape. Remove adhesive tape slowly
and evenly; do not use jerky movements. Do not leave adhesive tape on surfaces any longer than necessary, in order to
minimise the possibility of residues when removing. Also observe the adhesive tape manufacturer's instructions.
Description (Fig. 1)
Nozzle 311

Nozzle 517/619

2 Inlet valve pusher
4 Integrated toolbox for nozzles and small parts
6 Hose connection
8 Holder for paint container
10 Return hose
12 Operating instructions
14 Spray Gun
16 Nozzle holder
18 Gun filter: red (1 pc.), white (1 pc.*)
Filter red
Filter white
GB
21