Installation Of Removable Switch Housing - Hinkley LAFAYETTE 52" Manual De Instrucciones

INSTALLATION OF REMOVABLE SWITCH HOUSING

Mounting plate
Fig. 1
1
Remove the 1 of 3 screws from the mounting hub and keep it
for future use. Loosen the other 2 screws. (Do not remove)
Place the key holes on the mounting plate over the 2 screws
2
previously loosened from the mounting hub , turn mounting
plate until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened
and the one previously removed. (Figure 1)
Mounting Hub
(bottom of motor)
Screws
Fig. 2
1
2
3
Wire connectors
Detachable
Switch housing
Remove the 1 of 3 screws from the mounting plate and loosen
the other 2 screws. (Do not remove)
Raise and hold the DetachableSwitch housing close to the
mounting plate and push the square wire connectors together.
(Fig. 2)
Place the key holes on the DetachableSwitch housing over the
2 screws previously loosened from the mounting plate, turn light
kit until it locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened and the
one previously removed. (Fig. 2)
©2019 Hinkley Lighting, Inc. | hinkley.com |
Mounting plate
11