LG LRE3027ST El Manual Del Propietario página 37

EasyClean™ INSTRUCTION GUIdE
1. Remove oven racks and accessories from the oven.
2. Scrape off and remove any burnt-on debris with a plastic
scraper.
Suggested plastic scrapers:
• Hard plastic spatula
• Plastic pan scraper
• Plastic paint scraper
• Old credit card
3. Fill a spray bottle with 1¼ cups (10 oz or 300 ml) of water
and use the spray bottle to thoroughly spray the inside
surfaces of the oven.
4. Use at least ¼ cup (2oz or 50 ml) of the water to com-
pletely saturate the soil on both the walls and in the
corners of the oven.
5. Spray or pour the remaining 1 cup (8 oz or 250 ml) of
water onto the bottom center of the oven cavity. The
indentation on the oven bottom should be fully covered
to submerge all soils. Add water if necessary.
NOtE
Use the "mist" setting on the spray bottle for better
coverage. The entire 1¼ cup (10oz or 300 ml) of water
should be used for each oven cavity cleaned.
Do not spray water directly on the door. Doing so will
result in water dripping to the floor.
6. Close the oven door.
Press the EasyClean™ button.
Press the START button.
cAUtiON
y Some surfaces may be hot after the EasyClean™ cycle.
Wear rubber gloves while cleaning to prevent burns.
y During the EasyClean™ cycle, the oven bottom be-
comes hot enough to cause burns. Wait until the cycle
is over before wiping the inside surface of the oven.
Failure to do so may result in burns.
y Avoid leaning or resting on the oven door glass while
cleaning the oven cavity.
cARE ANd cLEANiNg
7. A tone will sound at the end of the 20-minute cycle.
Press the CLEAR OFF button to clear the display and end
the tone.
8. After the cleaning cycle and during hand-cleaning,
enough water should remain on the oven bottom to
completely submerge all soils. Add water if necessary.
Place a towel on the floor in front of the oven to capture
any water that may spill out during hand-cleaning. If you
are cleaning the upper oven on a double oven range, it is
also best to cover the holes in the top of the lower oven
door with a towel to capture any water that may drip into
the door during hand-cleaning.
9. Clean the oven cavity immediately after the
EasyClean™ cycle by scrubbing with a wet, non-scratch
scouring sponge or pad. (The scouring side will not
scratch the finish.) Some water may spill into the bottom
vents while cleaning, but it will be
captured in a pan under the oven
cavity and will not hurt the burner.
NOtE
DO NOT use any steel scouring pads, abrasive pads or
cleaners as these materials can permanently damage the
oven surface.
10. Once the oven cavity is cleaned, wipe any excess water
with a clean dry towel. Replace racks and any other ac-
cessories.
11. If some light soils remain, repeat the above steps,
making sure to thoroughly soak the soiled areas. If
stubborn soils remain after multiple EasyClean™ cycles,
run the Self Clean cycle. Be sure that the oven cavity is
empty of oven racks and other accessories, and that the
oven cavity surface is dry before running the Self Clean
cycle. Consult the Self Clean section of your owner's
manual for further details.
NOtE
y If you forget to saturate the inside of the oven with
water before starting EasyClean™, press the CLEAR
OFF button to end the cycle. Wait for the range to cool
to room temperature and then spray or pour water
into the oven and start another EasyClean™ cycle.
y The cavity gasket may be wet when the EasyClean™
cycle finishes. This is normal. Do not clean the gasket.
y If mineral deposits remain on the oven bottom after
cleaning, use a cloth or sponge soaked in vinegar to
remove them.
37