DeWalt DXCMLA1983012 Manual De Instrucciones página 23

CODE POSSIBLE CAUSE
Compressor cylinder finish worn
13
14 Regulator is not adjusted correctly for accessory
being used.
Damaged regulator
15
16 Regulator open
17 Low voltage/motor overload
18 Restricted air passages
19 Low voltage motor
Bad check valve
20
21 Seized pump
22 Poor ventilation
Dirty cooling surfaces
23
24 Too much back pressure in tank.
Compressor too cold
25
POSSIBLE SOLUTION
Contact a D WALT factory service center or a D
e
service center.
It is normal for some pressure drop to occur when and acces-
sory is used, adjust the regulator as instructed in Regulator under
Features if pressure drop is excessive.
NOTE: Adjust the regulated pressure under flow conditions while
the accessory is being used.
Replace
Roate the regulator knob counter-clockwise to its built-in stop.
Check that power supply is adequate and that compressor is
on a dedicated circuit. If using extension cord, try using without.
If compressor is connected to a circut protected by a fuse, use
dual element time delay fuses (Buss Fusetron type "T" only).
Inspect and replace transfer tubes or check valve, as required.
Furnish adequate powder.
Replace check valve.
Contact a D WALT factory service center or a D
e
service center.
Relocate compressor to an area with cool, dry, well circulated
air, at least 12 in. from nearest wall.
Clean all cooling surfaces thoroughly.
Open drain valve when starting motor.
Move compressor to a warmer location.
23
WALT authorized
e
WALT authorized
e