5.- FITTING THE FOOT REST
FOCUS BARS.-
Place the left foot bar (8) on the rail and
insert the washer (45) and the screw
(68) on the axis.
Conect the left foot rest (10) with the
left focus bar (6) and secure it using the
screw (72).
Put the lower bar covers (27) (28) on
the left focus bar (6) using the screws
(62),
Fig.6.
assembly with the right foot bar (9).
Put the bushing (85) on the left foot bar
(8) using the screw (70) and the nut
(57), Fig.7.
Perform the same assembly on the
right side.
6.- FITTING THE MONITOR.-
Take hold of the monitor (39) and bring
it up to main post (3), connect the
terminals, coming out of the bottom of
the monitor, with terminals (88) and
(90) coming up out of the top of the
main post (3), Fig.8.
Attach the monitor (39) using screws
(65), Fig.8, making sure not to pinch
the wires.
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
Perform
the
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (37) up or down, as shown in
Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (35),
as shown in Fig.9, which make it easier
same
to move.
The two wheels at the front of the unit
make it easier to place the unit in to
any chosen position by lifting the rear
slightly.
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Plug the adaptor into a 230 V mains
supply, Fig.10.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
19