Power Supply; Connecting To Power - Roadstar TTR-8632UCEN Manual De Instrucciones

REMOTE CONTROL
BATTERY INSTALLATION
the infra-red transmitter requires 2 pcs AAA size battery for operation (not included).
BUTTONS DESCRIPTION
1) FIND in MP3/WMA mode, press to activate file/folder name search function.
2) INFO in USB stop mode, press to select encoding bitrate.
3) REC in PHONO mode, press to activate recording function.
4) REP/INTRO/RAN in USB mode, press to activate Repeat one/ Repeat All/ Folder/ Intro/
/ Random functions.
5) PROGRAM in USB mode, press to active programming function.
6) PLAY/PAUSE in USB mode, press once to start playback. press again to enter
pause mode.
7) SKIP/SEARCH forward press once to Skip to next track.
Press & hold for search forward
SKIP/SEARCH backward press once to Skip to previous track.
Press & hold for search backward.
8) STOP in USB mode, press to stop playback or cancel the stored
program.
9) FOLDER up /down in MP3 mode, press to selec tFolder up or down.
10) SOURCE in USB mode, press to select USB/CARD function repeatly.

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
English
3
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user
serviceable parts inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only

POWER SUPPLY

Remove the stereo carefully from the box, retaining the packaging for future use (servicing).
AC POWER OPERATION
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
MW/FM TUNER
Operation
•
•
•
ANTENNA
•
•
FM & FM-STEREO RECEPTION
•
•
•
English
4
This symbol means that this unit is double insulated. An earth connection is not
required.
Set the Function Selector (7) to the RADIO position.
The red Power Indicator (5) will light up.
Select the desired frequency band with the Band Selector (10).
Tune to the desired radio station by turning the Tuning control (19).
For FM reception there is a built-in FM antenna wire (28) at the rear of the unit. Move the
wire around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite antenna. Your may
have to orient the unit to obtain the best reception.
Stereo reception is possible when the tuned FM station is broadcasting in stereo.
When in FM STereo mode and the station is broadscasting in Stereo, the STEREO
indicator (20) lights up.
When FM stations are weak and are disturbed, listening can be improved by switching
the Band selector to FM (Mono). Reception will then be in MONO.