Agilent Technologies TwisTorr 404 FS Serie Manual De Istrucciones página 310

17 Technical Information
TwisTorr 404 FS On Board Controller Installation
3
4
5
6
7
8
9
Figure 38
310/328
Place the bracket on the pump bottom (the hole on the bracket
has the same diameter as the pump bottom flange);
Screw a little bit the three screws M6 in the holes on the pump
bottom;
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
TwisTorr 404 FS User Manual / 87-901-048-01