For Your Safety - Saber R33SC0012 Manual De Uso

LP Cylinder Exchange
Many retailers that sell grills offer you the option of replacing your

empty LP cylinder through an exchange service. Use only those
reputable exchange companies that inspect, precision fill, test
and certify their cylinders. Exchange your cylinder only for an
OPD safety feature-equipped cylinder as described in the
"LP Cylinder" section of this manual.
Always keep new and exchanged LP cylinders in upright position

during use, transit or storage.
Leak test new and exchanged LP cylinders BEFORE

connecting to grill.
LP Cylinder Leak Test

For your safety

Leak test must be repeated each time LP cylinder is exchanged

or refilled.
Do not smoke during leak test.

Do not use an open flame to check for gas leaks.

Grill must be leak tested outdoors in a well-ventilated area, away

from ignition sources such as gas fired or electrical appliances.
During leak test, keep grill away from open flames or sparks.
Use a clean paintbrush and a 50/50 mild soap and water

solution. Brush soapy solution onto areas indicated by arrows in
figure below.
Do not use household cleaning agents. Damage to gas train

components can result.
WARNING
If "growing" bubbles appear do not use or move the
LP cylinder. Contact an LP gas supplier or your fire
department!
4
Connecting Regulator to the LP Cylinder
1. LP cylinder must be properly secured onto grill. (Refer to
assembly section of your grill manual).
2. Turn all control knobs to the OFF position.
3. Turn LP cylinder OFF by turning hand wheel clockwise to a
Full Stop.
4. Remove the protective cap from LP cylinder valve. Always use
cap and strap supplied with valve.
Safety Relief Valve
5. Hold regulator and insert nipple into LP
cylinder valve. Hand-tighten the
coupling nut, holding regulator in a
straight line with LP cylinder valve so
as not to cross-thread the connection.
Nipple has to be centered
into the LP cylinder valve.
OPD Hand Wheel
Type 1 outlet with
thread on outside
Strap and Cap
Do not use a POL transport
plug (plastic part with external
threads)! It will defeat the
safety feature of the valve.