GE PGP976 Manual Del Usuario página 12

Installation Instructions
MAKING THE LP CONVERSION
r_ SAFETY INFORMATION YOU
SHOULD KNOW
The pressure regulator and burner orifices are set
for natural gas. To use LP gas, the regulator and
burner orifices must be converted. The LP orifice
spuds for the cooktop burners can be located in the
literature package attached to the regulator.
A ,,-. A, ,-T,,,,,_ L,
,ltL,/'_L,I/IUi_I: The cooktop, as shipped from
the factory, is set for use with natural gas. If you
wish to use your cooktop with LP gas, you must
first replace the orifices and convert the pressure
regulator.
Ai i m^_L,,L,,_
AILW/"_K|_I I i_1_:
Thisconversionmust be
performed by o qualified i nstaller or gas supplier in
accordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work assumes
responsibility for the conversion.
ACAUTION:
The following adjustments
must be made beforeturningon the burner. Failure
to do so could result inserious injury. Be sure
pressureregulotor has been converted as
describedinStep 2.
TOOLS YOU WILL NEED
FOR LP CONVERSION
7mm Nutdriver
Safety Glasses
Small Flat-Head
Screwdriver (4mm or
5/32" tip size, 60mm
long)
B]
Fa
ADJUST YOUR COOKTOP FOR USE
WITH LP GAS
Disconnect all electrical power, at the main
circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator, by the following
instructions:
* Unscrew the cap.
* Place your thumb against the flat side of the
spring retainer and press down to remove
the retainer.
* Carefully look at the spring retainer to locate
the NAT or LP position.
Cap Gosket
_ _///_@ Spring
NAT/__'"" n_L. p,_proii:i net
Position Position
Pressure Regulator
* Turn the spring retainer over so that LP is
showing on the bottom.
* Snap the retainer back into position.
* Screw the cap back onto the regulator.
12