GE PGP976 Manual Del Usuario página 13

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
[_ CHANGE COOKTOP BURNER
ORIFICES
FA1 Remove the grates, burner cops, and burner
heads.
[] Using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
Inner j,_Q
burner cap
Burner ,S'_ Outer
base --'-__' _- burner
cap
Electrode
Burner
Orifice spuds located _l/
through these openings
Tri-Ring Burner
OR
BurNer
base
Burner
cap
Burner
head
Orifice spud located Electrode
through this opening
Retainer
Ring
NOTE: On all burners, the
orifices hove a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
Fcl Locate the LP/Propane orifices shipped inside
the literature package. They will hove a digit
number and the letter "L" on the side.
(important: Save the orifices removed from the
appliance for future use.)
Each orifice will show a series of engraved
murks, (I, II, III, IV or V), located on the top.
These murks denote the location of each orifice to the
cooktop burner.
For PGP976 Models
For PGP986 & CGP650 Models
See instructions
for center burner
r_ CHANGE COOKTOP BURNER
ORIFICES (CONT.}
CENTER BURNER
17,000 BTU/hr Extra Large Burner (PGP976 Models)
Extended spud for center
extra large burner
O urner
Cap
_Set Screw
I
_I_ Choke
I
Extended
Spud
Burner
Head
Base
Orifice spud located
through this opening
13