Install Backsplash; Install The Hood - Broan best K29 Manual Del Usuario

INSTALL BACKSPLASH

If optional Model BSK1 series backsplash is
used, attach it to the finished wall. Secure hood
mounting brackets to the backsplash and omit
wall framing described below.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
steel ductwork.
1. Decide where the ductwork will run between
the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible.
4. Install a roof or wall cap. Connect 6" round
steel ductwork to cap and work back towards
hood location. Use duct tape to seal the joints
between ductwork sections.
INSTALL MOUNTING
BRACKETS
1. Construct wood wall framing that is flush
with interior surface of wall studs.
Make sure:
a) the framing is centered over installation
location.
b) the height of the framing will allow the
mounting brackets to be secured to the
framing within the dimensions shown.
2. After wall surface is finished, secure mount-
ing brackets to framing using dimensions
shown.

INSTALL THE HOOD

1. Hang the hood from the brackets through
the rectangular cut-outs on the back of the
hood. Cut-outs are larger than the brackets
to allow for horizontal adjustment.
The bottom of the hood should be 24" to 30"
above the cooking surface.
2. Height adjustment screws provide vertical
adjustment.
3. Depth adjustment screws provide horizon-
tal adjustment.
4. Secure the hood with additional mounting
screws. Use drywall anchors, provided, if
wall studs or framing are not available.
(OPTIONAL)
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
31"= bottom of hood 24" above cooktop
37"= bottom of hood 30" above cooktop
RECTANGULAR CUTOUTS
MOUNTING SCREWS
DEPTH ADJUSTMENT
HEIGHT
ADJUSTMENT
SCREWS
ADDITIONAL MOUNTING SCREWS
- 4 -
ROOF CAP
6" ROUND
DUCT
FRAMING BEHIND DRYWALL
MOUNTING
BRACKETS
ADDITIONAL
SCREWS
WALL
CAP
6" ROUND
ELBOW
WALL
FRAMING