Display Language (Only Toronto 410 Bt); Setting The Reception Area; Switching On/Off; Volume - Blaupunkt Madrid 210 Instrucciones De Manejo

Placing the device in operation
Attaching the control panel
u
Push the control panel into the bracket at the
right edge of the device.
u
Push the control panel carefully into the left
bracket until it clicks into place.
Removing the control panel
u
Press the button
panel.
The left side of the control panel detaches
from the device and is secured by the bracket
against falling out.
u
Move the control panel slightly to the left
until it disengages from the right bracket.
u
Carefully remove the control panel from the
left bracket.
Note:
The car sound system automatically switches
off as soon as the control panel is removed.
Display language
(only Toronto 410 BT)
For the Toronto 410 BT, you can defi ne whether
the language for messages on the display is Eng-
lish or German. The setting is performed in the
user menu (see the chapter "User settings", section
"Making settings in the "DISPLAY" menu", menu
item "LANGUAGE" ).

Setting the reception area

This car sound system is designed for opera-
tion in diff erent regions with diff erent frequency
ranges and station technologies. The factory de-
fault of the reception area is "EUROPE". In addi-
tion, the reception areas "USA", "THAILAND" and
"SOUTH AMERICA" are available.
Note:
If you operate the car sound system outside
of Europe, you may fi rst have to set a suit-
able reception area in the user menu (see
the chapter "User settings", section "Making
settings in the "TUNER" menu", menu item
"TUNER AREA").
28
1
to unlock the control

Switching on/off

Switching on/off with the On/Off button
u
For switch-on, press the On/Off button
The car sound system switches on.
u
To switch off the device, press and hold down
the On/Off button
onds.
The car sound system switches off .
Note:
If you switch on the car sound system while
the vehicle ignition is switched off , it auto-
matically switches off after 1 hour to preserve
the vehicle battery.
Switching on/off via vehicle ignition
The car sound system will switch off /on simulta-
neously with the ignition if the device is correctly
connected to the vehicle's ignition as shown in the
installation instructions and you did not switch the
device off by pressing the On/Off button

Volume

Adjusting the volume
You can adjust the volume in steps from 0 (off ) to
50 (maximum).
u
Turn the volume control
volume.
Note:
If a telephone or navigation system is con-
nected with the car sound system as de-
scribed in the installation instructions, the car
sound system is muted in case of a telephone
call or navigation announcement so that
you can hear the playback of the telephone
or navigation system undisturbed. While it is
muted, the display shows "TELEPHONE".
Muting the car sound system (Mute)
u
Briefl y press the On/Off button
the car sound system or to reactivate the pre-
vious volume.
While it is switched low, the display shows
"MUTE".
3
3
for longer than 2 sec-
3
.
4
to change the
3
to mute
.