Velleman RCQC1 Manual Del Usuario página 6

3. Connect the battery to the included USB cable and connect to a switched-on USB output. The LED
will switch on as soon as the battery is fully charged. Disconnect the battery from the USB output,
slide battery into the quadcopter, connect to the power input and close the battery compartment.
7.2 Installing the Landing Skids and Blade Protectors
1. Place the landing skids on the bottom of the quadcopter and fix with the screws.
2. Place one blade protector onto each arm and fix with the screw.
7.3 Synchronizing the Remote Control and Quadcopter
If you have not done so, install the charged
battery into your quadcopter. Also, install the
batteries in the remote control.
Push and hold the throttle stick completely
downwards.
If synchronizing has failed – if the orientation LEDs are still blinking – or if the quadcopter is
beyond control, switch off both the quadcopter and the remote control, and start the
synchronizing procedure again.
If the orientation LEDs blink slowly, please recharge the quadcopter's battery.
V. 06 – 09/11/2017
RCQC1
Switch on your quadcopter by sliding the on-
off switch to the on position. Place the
quadcopter on a flat surface.
Switch on your remote control by sliding the
on-off switch to the on position. Synchronizing
has been completed when the remote control
beeps twice and the quadcopter's orientation
6
LEDs burn steadily.
©Velleman nv