Menu Overview - Velleman DVRSD1 Manual Del Usuario

1 DC 12V in
2 DIN connector (see below)
3 Video 1 input
4 Video 2 input
5 Video output connector
6 power indicator
7 detect indicator
8 SD card slot
9 power ON/OFF switch
6. Installation
Refer to the illustrations on page 2 of this manual.
• Insert a suitable SD card into the card slot [8]. Make sure the overwrite protection is not enabled.
• Connect the cameras (not incl.) to the video inputs [3, 4]. It is possible to power the cameras via
the DIN connector. Insert the DIN cable into the connector [2] and connect one of the red power
plugs to the camera.
Note: max. Current is 600mA through both plugs, so either connect two cameras each requiring
max. 300mA or one camera that draws max. 600 mA.
• When the cameras support sound, connect the appropriate audio inputs via the DIN cable: connect
audio from video 1 to the yellow RCA, from camera 2 to the red RCA.
• Connect a monitor (not incl.) to the video output connector [5]. When applicable, also connect the
audio out connector from the DIN cable (white RCA) to the monitor. The monitor needs its own
power supply.
• Connect the included power adaptor to the 12Vdc input [1] and plug the adaptor into a suitable
mains outlet.
• Switch the power switch [9] to the ON-position. The power indicator [6] lights up.

7. Menu overview

Press the MENU button [15] to enter the on-screen menu.
•
Use the UP [14], DOWN [18], LEFT [16] and RIGHT [17] buttons to navigate through the menus.
•
Press OK/SHOT [15] to enter a submenu or accept a setting.
•
Photo 1
Photo 3
Manual capture Movie
Movie clip
EXIT
Auto capture
Master capture
Auto capture
Movie prerecord
File overwrite setting
EXIT
22.09.2011
DVRSD1
10 MODE button
11 DISP button
12 SHOT button
13 ZOOM button
14 UP button
15 MENU/OK button
16 LEFT button
17 RIGHT button
18 DOWN button
capture 1 picture
capture 3 pictures
start/stop recording 1 AVI video
start/stop recording short AVI videos (1 minute)
On switch auto-capture function on
Off switch auto-capture function off
EXIT
Photo 1 auto-capture 1 picture
Photo 3 auto-capture 3 pictures
Movie 5s auto-capture 5s movie
Movie 10s auto-capture 10s movie
EXIT
Movie 5s set pre-record time to 5s
Movie 10s set pre-record time to 10s
Off no pre-recording
EXIT
On overwrite files when SD card is full
Off stop when SD card is full
EXIT
4
©Velleman nv