Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Fitting Kit
K325
Select plastic packer blocks from fitting kit
and insert into fixed-points. Blocks have L &
R which should be read from beside vehicle.
"L" should point to your left and "R" should
point to your right.
Position crossbar so hole in centre of metal
loadplate lines up through packer block with
threaded insert in fixed-point. If standing on
the right side of vehicle, use hole marked
"R". If on the left use hole marked "L".
Tighten adjusting screw to 5 Nm (3.7 ft lb).
When fitting type B crossbars, tighten using
Hex Key located inside one of the right hand
side covers to assist.
Using long capscrew and washer, secure
assembly onto leg (use Hex Screwdriver
supplied with crossbar to assist).
11
Publicidad
