Sony VPL-FE100U Manual De Instrucciones página 32

Setting the Index Numbers
Notes on connections when two or more
switchers are used
• Mount the IFB-12A interface board to the slot 1 of
the number n switcher and connect the output
connector of the number (n+1) switcher to the
IFB-12A.
• You can attach the IFB-12A signal interface board
(when the IN/OUT switch is set to OUT) only to
the number 1 switcher.
To select the projector by designating the
index numbers
When the switchers and projectors are connected as
illustrated, select the desired projector by pressing the
keys on the Remote Commander as shown below.
PC-3000
Signal flow
PC-3000
Signal flow
Projector A
Signal flow
Projector B
Group index 01
PJ COM
PC-3000
Signal flow
PC-3000
Signal flow
Projector C
Signal flow
Projector D
Group index 02
32
(GB)
Number 2 switcher
PJ COM
Number 1 switcher
PJ COM
Device index 01
PJ COM
Device index 02
Number 2 switcher
PJ COM
Number 1 switcher
PJ COM
Device index 01
PJ COM
Device index 02
Example:
To select all the projectors
GROUP n ALL n ENTER n ALL n
ENTER
Projectors A, B, C and D are selected.
To select projectors with device index 01 from all the
groups
GROUP n ALL n ENTER n 1 n ENTER
Projectors A and C are selected.
To select a projector with device index 01 from group
index 02
GROUP n 2 n ENTER n 1 n ENTER
Projector C is selected.
To select all the projectors from group index 02
GROUP n 2 n ENTER n ALL n ENTER
Projectors C and D are selected.
Notes
• Set the group index and device index numbers
correctly. If more than two projectors are set to the
same group index and device index numbers, an error
message will be displayed when the SYS SET key is
pressed.
• If the group index is a tens digit number, press the
GROUP key before each press of the number key.
Example:
To select a projector with device index 13 of group
index 12
GROUP n 1 n GROUP n 2 n ENTER n
1 n 3 n ENTER