Sony VPL-FHZ75 Manual De Referencia Rápida página 44

On Illumination
To obtain the best picture, the front of the
screen should not be exposed to direct
lighting or sunlight.
On Heat Dissipation
The temperature of the projector cabinet
may increase during or immediately after
use; however, this is not a malfunction.
On Screen
When using a screen with an uneven surface,
stripes pattern may rarely appear on the
screen depending on the distance between
the screen and the unit or the zooming
magnifications. This is not a malfunction of
the unit.
On Fan
Since the projector is equipped with a fan
inside to prevent internal temperature from
rising, there may be some noise. This is a
normal result of the manufacturing process
and does not indicate a malfunction. If,
however, in a case of abnormal noise,
consult with qualified Sony personnel.
About Lens Replacement
When the power is connected, do not attach
or remove the projection lens.
Do not attach any lens other than the
specified accessory lens sold separately.
On inspection of light source
related parts
Since the unit uses a laser, when performing
maintenance or inspection of light source
related parts, particular attention and a safe
environment are necessary. Be sure to
consult with qualified Sony personnel.
14
GB
On disposing used products
Do not dispose the used products and
general garbage together.
Correctly dispose of used products to avoid
harming the environment or the health of
yourself and others. Follow the disposal
regulations of your area.
On LCD Projector
The LCD projector is manufactured using
high-precision technology. You may,
however, see tiny black points and/or bright
points (red, blue, or green) that continuously
appear on the LCD projector. This is a
normal result of the manufacturing process
and does not indicate a malfunction.
Also, when you use multiple LCD projectors
to project onto a screen, even if they are of
the same model, the color reproduction
among projectors may vary, since color
balance may be set differently from one
projector to the next.
On condensation
If the room temperature where the projector
is installed changes rapidly, or if the
projector is moved suddenly from a cold to a
warm place, condensation in the projector
may occur. As the condensation may cause
malfunction, be careful in adjusting
temperature settings of the air conditioner. If
condensation occurs, leave the projector
turned on for about two hours before use.
Notes on security
• SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND
RESULTING FROM A FAILURE TO
IMPLEMENT PROPER SECURITY
MEASURES ON TRANSMISSION
DEVICES, UNAVOIDABLE DATA
LEAKS RESULTING FROM
TRANSMISSION SPECIFICATIONS,
OR SECURITY PROBLEMS OF ANY
KIND.