KOBE IS2236SQF Instrucciones De Instalación Y Manual De Operación página 9

Preparations of Ductwork and Location
NOTE: TO AVOID DAMAGE TO YOUR
HOOD, PREVENT DEBRIS FROM
ENTERING THE VENT OPENING.
- Decide the location of the venting pipe from
the hood to the outside. Refer to Figure 1.
- A straight, short venting run will allow the
hood to perform more efficiently.
- Try to avoid as many transitions, elbows,
and long run as possible. This may reduce
the performance of the hood.
- Temporarily wire the hood to test for proper
operation before installing.
-
Important: Peel any protective film off the hood
-
Use duct tape to seal the joints between
pipe sections.
Telescopic Stack Installation
1. Mark centerlines of cook top or range on
ceiling above. Use centerlines marked on
ceiling to position the mounting template
as shown in Figure 2.
2. Remove and save template.
remove ceiling drywall.
cross framing lumber (not provided)
between ceiling joists. Refer to Figure 3.
Consult a professional if you have
difficulty or your installation is unique.
3. Finish the ceiling surface.
mark the location of the ceiling joists and
cross framing, or replace the mounting
template in the position of the ceiling joists
& cross framing.
4. Attach the telescopic stack to the ceiling
and securely fasten to the joists and cross
framing with eight screws (not provided)
as shown in Figure 3. Make sure screws
are driven into center of joists and cross
framing for maximum support.
5. Adjust the
reference F calculated in Table 1 and
measurements on page 12. Tighten from
the side with four (4x8 mm) screws
(provided) as shown in Figure 3.
Cut and
Install 2" x 4"
Be sure to
telescopic stack
Figure 1
Figure 2
Figure 3
using
7