Fein AGWP 10 Manual De Instrucciones página 17

OBJ_BUCH-0000000253-001.book Page 17 Tuesday, February 16, 2016 2:53 PM
Character Unit of measure-
ment, international
U
V
n
/min, min
0
r/min
n
/min, min
1R
r/min
n
/min, min
1L
r/min
Ø mm
mm
Fe
mm
Al
mm
mm
mm
kg
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
2
m/s
h,D
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Hand-guided tapper for cutting threads in through holes
and blind holes in weather-protected environments
without water supply using the application tools and
accessories recommended by FEIN.
Unit of measure-
ment, national
V
-1
, rpm, rpm
-1
, rpm, rpm
-1
, rpm, rpm
mm
mm
mm
mm
mm
mm
kg
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
Special safety instructions.
Use auxiliary handle(s), if supplied with the tool. Loss of
control can cause personal injury.
Hold power tool by the insulated gripping surfaces, when
performing an operation where the cutting accessory
may contact hidden wiring. Cutting accessory contacting
a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
Beware of any concealed electric cables, gas or water
conduits. Check the working area before commencing
work, e. g. with a metal detector.
Secure the work piece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
Hold the power tool firmly. High reaction torque can
briefly occur.
Do not direct the power tool against yourself, other per-
sons or animals. Danger of injury from sharp or hot
application tools.
Do not rivet or screw any name-plates or signs onto the
power tool. If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
Explanation
DC voltage
No-load speed
Load speed (clockwise rotation)
Load speed (anticlockwise rotation)
Diameter of a round part
Drilling diameter, steel
Drilling diameter, aluminium
Drilling diameter, wood
Tap
d = Thread size of shaft
1
d = Clamping range of drill chuck
2
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to
EN 60745 (vector sum of three directions)
Mean vibrational value for drilling in metal
Basic and derived units of measurement from the
international system of units SI.
en
17