LD Systems CURV 500 Serie Manual De Usuario página 7

7
POWER LED
Lights up once the system is properly connected to the power mains and switched on.
8
POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Replace the
fuse only with a fuse corresponding to the operating voltage. Please observe the label on the housing. If the fuse blows repeatedly, please
contact an authorised service centre.
9
POWER ON / OFF
On / Off switch for the power supply of the device.
10
SATELLITE OUT LEFT / RIGHT
Speakon compatible outputs for controlling the LD CURV 500
outputs simultaneously (e.g. for voice and sound). When using a CURV 500
for the control of the LD CURV 500 satellites and the MONO / STEREO (26) on the mixer control panel switch must be pressed down (MONO).
When using a LD CURV 500 ES Entertainer Set as a Stereo Set (2 array satellites mounted left and right), or when using the LD CURV 500
®
AVS A/V Set, use both satellite outputs LEFT and RIGHT to control the LD CURV 500
switch on the mixer control panel must not be pressed down (STEREO). An incoming stereo audio signal will be output in stereo. The use of
the LD CURV 500 PS Power Set as a Stereo Set (or the combination of LD CURV 500
®
satellite output LEFT (left) for the control of the LD CURV 500
the satellite output of the expansion subwoofer SATELLITE OUT RIGHT.
11
LED CH 1
When a signal is present at the input of channel 1 (CH 1), the LED indicator lights up green; if the LED is red, the channel is operating at the
clipping range. To avoid distortion, reduce the volume level of the volume controller (12) of channel 1.
12
LEVEL CH 1
Volume controller for channel 1 (CH 1). Turning the dial to the right increases the volume and turning it to the left decreases it.
13
EQUALIZER HIGH CH 1
Equalizer high band for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised. In the centre
position (resting point), the equalizer is inactive.
®
®
11 16
12
17
13
18
14 19
15
20
satellites. Up to four LD CURV 500® satellites can be operated at each of the
ES Entertainer Set as a Mono Set, use the satellite output LEFT
®
satellites left and right and the MONO / STEREO (26)
®
ES and LD CURV 500
®
satellite on the left. The LD CURV 500
21
22
23
24
25
26
PES) requires the use of the
®
satellite on the right is controlled by
®
27
28
29
30
31
®
7