Maintenance; Cleaning Vac Filter; Filter Removal And Installation - RIDGID 4000RV0 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SP6938-1 4 gallon ESF1_SP6938-1 1/16/15 10:52 AM Page 8

Maintenance

Cleaning Vac Filter

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter or foam pad.
NOTE: The filter is made of high quality
paper designed to stop very small particles
of dust. The filter can be used for dry pick
up or small amounts of liquid. Handle the
filter carefully when removing to clean or
installing it. Creases in the filter pleats may
occur from installation but will not affect the
performance of the filter.

Filter Removal and Installation

WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate Vac
with any parts damaged or missing.
To Remove Power Head:
1. Grasp the drum latches on both the
right and left side of the power head.
Slowly pull the drum latches away from
the drum. Lift the power head off the
drum. Place the lid assembly of the
Vac upside down.
Power
Head
Flexible Locking Tab
Pull
Out
And
Lift Up
Drum
Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Filter
Cage
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
8
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik Lock™
Stud

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido