Milwaukee M12-18 FC Manual Original página 9

is not necessary to run down the battery pack before placing it on
the charger.
As a general practice, it is best to unplug battery chargers and
remove batteries when not in use. No battery pack damage will
occur, however, if the charger and battery pack are left plugged in.
If both LEDs fl ash alternately then the rechargeable battery is
either not fully pushed in or there is a fault with the battery or
charger. Take the charger and battery out of use immediately for
safety reasons and have them inspected by a Milwaukee customer
service centre.
Both 12V and 14.4/18V battery packs can be inserted into the
charger at the same time, but they will be charged one after the
other. The fi rst battery pack to be inserted will be the fi rst one to be
charged. The red LED for the second battery pack will fl ash slowly
to indicate that the charging process has not begun yet.
LIGHT INDICATORS
Continuous red
Slow fl ashing green
Continuous green
Fast fl ashing red
Slow fl ashing red
Flashing red/green
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and insulated
to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
If the supply cord of this appliance is damaged, it must only be
replaced by a repair shop appointed by the manufacturer, because
special purpose tools are required
414 697 - M12-18FC.indd Abs1:9 414 697 - M12-18FC.indd Abs1:9
Charging
Approaching full charge
Charging is complete
Battery is too hot/cold -
Charging will begin when battery
reaches correct charging
temperature
Battery charge is pending -
Charging will begin when the
fi rst pack is fully charged
Damaged or faulty battery pack
Use only Milwaukee accessories and Milwaukee spare parts.
Should components need to be replaced which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting.
Do not burn used battery packs.
Do not dispose of electric tools together with household
waste material.
Electric tools and electronic equipment that have
reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
Check with your local authority or retailer for recycling
advice and collection point.
Never charge a damaged battery pack.
Replace with a new one.
This tool is only suitable for indoor use. Never expose
tool to rain.
T5.0A
Time-lag fuse 5 A
Double isolated
European Conformity Mark
EurAsian Conformity Mark.
ENGLISH 9
15.06.2016 22:05:36 15.06.2016 22:05:36