ASSEMBLY INSTRUCTIONS
4. Place mesh (E) into the center of the basin (D). Fill
the basin with water, making sure the pump (C) is fully
submerged. Then, plug item into nearest outlet.
CAUTION:
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
Note:
This fountain is equipped with a tempera-
ture-detecting auto-shut off pump. When there is less
water in the fountain than the required minimum or the
pump runs dry, the pump can overheat and become damaged. This auto-shut off pump is designed to
deactivate the pump when it overheats. When this happens, the pump is not broken. Add more water
to cover the pump. When temperature of the pump drops, the pump will reactivate.
CARE AND MAINTENANCE
•
Keep water clean. Using clean water will reduce mineral deposits, improve water clarity and prolong
the life of the pump.
•
Check regularly that the water reservoir has sufficient water to cover the pump at all times. It will be
necessary to check more frequently in warm or windy weather.
•
The pump rotor will require cleaning at approximately monthly intervals. A good indication will be if
the water flow rate drops. Switch off and unplug the water feature, remove the pump from the water
reservoir and disconnect the water pipe. Remove the filtering cover and pressure-casing from the
front of pump body. Clean the rotor and housing in clean water using cotton buds. Reassemble the
pump, reconnect the water pipe and reassemble the water feature.
•
Periodically it will be necessary to change the water and clean the water feature and reservoir. The
•
frequency of this will depend on the weather and location of the water feature. The outside of the
water feature can be cleaned using a soft cloth and clean water and the reservoir with a soft brush.
A mild detergent can be used but please note that this will cause the water to foam and should be
avoided unless strictly necessary.
•
Disconnect the power and empty the basin if the fountain will not be used for an extended time.
•
If installed outdoors and in a freeze-prone area of the country, ensure all water is removed and the
unit is completely dry before temperatures drop too low. This product is NOT to be operated below
41°F or freeze damage may occur.
4
E
Model#
YH-LV70T
Frequence
60Hz
NOTE: The pump data in this manual is from
lab tests. The actual pump may be different
due to the method of production or technical
improvements. This data can be used as a
reference when purchasing a similar pump.
5
Description
Volt.
Temperature
120v
auto-shut off
pump
Flow Height
Flow Volme
75cm
310L / hour
Power
4.8W