Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
11 Remove appropriate Duct Knockout(s) from top or back of
hood.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
3¼" x 10" Ducted Discharge Only: Attach Damper/Duct
12
Connector over knockout opening. Make sure damper Pivot
is nearest to Top/Back Edge of hood. Remove Tape from
damper flap.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
13
Plate removed in Step #1 under "PREPARE THE HOOD"
section. Install a 7" round damper (purchase separately).
Damper flap must open freely in direction of air flow (away
from range hood).
To accomodate off-center ductwork, the Damper/Duct
NOTE
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to ½" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
TOP/BACK
TAPE
EDGE
DAMPER/DUCT
CONNECTOR
(Vertical discharge
position shown)
CONNECT WIRING
WARNING: To reduce the risk of electric shock,
make sure power is switched off at the service
panel. Lock or tag service panel to prevent power
from being switched on accidentally.
1
Connect House Wiring (120 VAC) to hood. Use a piece of
Cardboard to protect the cooktop, if necessary.
2
Connect house black to hood black wire, house white to hood
white wire, and house ground under Green Ground Screw.
Securely tighten cable clamp onto house wiring.
3
Replace wiring cover.
ALLURE™ QS1 SERIES
RANGE HOOD
Page 4
HOUSE
WIRING
(120 VAC)
CARDBOARD
(Use to protect
cooktop)
GROUND
GREEN
SCREW
Publicidad
