Service Information - EINHELL TC-SM 2131/1 Dual Manual De Instrucciones Original

fluctuate temporarily.
•
The product is intended solely for use at
connection points that a) do not exceed a ma-
ximum permitted mains system impedance of
Z sys = 0.25 + j0.15, or b) have a continuous
current-carrying capacity of the mains of at
least 100 A per phase.
•
As the user, you are required to ensure, in
consultation with your electric power compa-
ny if necessary, that the connection point at
which you wish to operate the product meets
one of the two requirements, a) or b), named
above.

11. Service information

We have competent service partners in all coun-
tries named on the guarantee certifi cate whose
contact details can also be found on the guaran-
tee certifi cate. These partners will help you with
all service requests such as repairs, spare and
wearing part orders or the purchase of
consumables.
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Drag, crosscut and miter saw
Category
Wear parts*
Consumables*
* Not necessarily included in the scope of deli-
very!
In the eff ect of defects or faults, please inform the
problem to the contact address indicated at the
warranty card of your country. Please
ensure that you provide a precise description of
the problem and answer the following questions
in all cases:
•
Did the equipment work at all or was it defec-
tive from the beginning?
•
Did you notice anything (symptom or defect)
prior to the failure?
•
What malfunction does the equipment have in
your opinion (main symptom)?
•
Describe this malfunction.
Anl_TC_SM_2131_1_Dual_SPK8.indb 49 Anl_TC_SM_2131_1_Dual_SPK8.indb 49
GB
Parts
Carbon Brushes
Saw Blade
- 49 -
09.07.2020 11:13:39 09.07.2020 11:13:39