Sustitución De La Fuente De Alimentación; Before You Begin - Altair AL-2150 Manual Del Usuario

SUSTITUCIÓN DE LA FUENTE DE ALIMENTACIÓN
No es necesario para la instalación inicial - sólo se requiere si la fuente de
alimentación ha dejado de funcionar).
1. CORTE EL SUMINISTRO ELÉCTRICO APAGANDO EL DISYUNTOR DE
CIRCUITOS.
2. Retire la lámpara de la pared y desconecte sus cables de los cables de alimentación.
3. Retire los TORNILLOS DEL ARMAZÓN y separe la CUBIERTA del ARMAZÓN. (Fig.
11/12)
Fig. 11
4. No toque los LEDs. Retire los TORNILLOS DE LA PLACA y separe la PLACA DE LED
de la CUBIERTA. (Fig. 13/14)
Fig. 13
Fig. 12
Fig. 14
Page 18
PARTS:
Remove fixture and mounting package from box and make sure that parts are not
missing by referencing illustrations below. (Parts are not to scale.)
Main Fixture
Body
CAUTION:
•
All electrical connections must be in accordance with local and National Electrical
Code (N.E.C.) standards. If you are unfamiliar with proper electrical practices, obtain
services of a qualified electrician.
•
Turn off the main power at circuit breaker before installing fixture, in order to prevent
possible shock.

BEFORE YOU BEGIN:

•
This fixture has a photocell light control located on the
front side of the hood. The LED lights will turn on when
the ambient light around the photocell has diminished to
a nighttime level. The lights will remain on until the
ambient light has risen back to a daylight level. Avoid
installing the fixture near nighttime light sources, such as
street lights or other light fixtures, which might prevent
the light from turning on.
•
The OUTLET BOX described in the following section is
not provided. To install this fixture, a standard OUTLET
BOX needs to be pre-installed in the wall at the selected mounting location. Power
supply wires need to be run to the OUTLET BOX providing 120 VAC of power. If an
OUTLET BOX does not exist, contact a qualified electrician to have one installed.
•
Remove the CAGE SCREWS and separate the CAGE from the HOOD. (Fig. 11/12)
•
Remove the cardboard rings under the HOOD and then reattach the HOOD to the
CAGE using the CAGE SCREWS. (Fig. 0)
Decorative
Cap Mounting Bracket
Top Loop
Optional Arm Assembly
Bracket Mounting
Wire Nuts (3)
Screws (2)
Page 3
Fig. 0