Troubleshooting - Altair AL-2150 Manual Del Usuario

ENSAMBLAJE E INSTALACIÓN:
ENSAMBLAJE
1. Coloque la TAPA
DECORATIVA sobre el
ACOPLADOR de la
CUBIERTA. (Fig. 1)
2. Inserte el NIPLE de la ARGOLLA
SUPERIOR en la TAPA
DECORATIVA y luego en el
ACOPLADOR. Gire la ARGOLLA
SUPERIOR hasta que quede
ajustada y paralela a la PLACA DE
PARED. (Fig. 2)
3. Retire los TORNILLOS De
LA CUBIERTA. (Fig. 3)
Separe el CUERPO
PRINCIPAL DE LA
LUMINARIA del
ARMAZÓN. (Fig. 4)
Retire el PROTECTOR
DE CARTÓN (no se
muestra) de la PANTALLA
DE VIDRIO. Vuelva a
colocar el CUERPO
PRINCIPAL DE LA
LUMINARIA en el
ARMAZÓN. (Fig. 4)
Asegure el ARMAZÓN al
CUERPO PRINCIPAL DE
LA LUMINARIA usando
los TORNILLOS DE LA
CUBIERTA. (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Page 14
BRACKET
MOUNTING
FIXTURE
GROUND SCREW
WIRE
LOCK
NUT
BLACK
WALL
FIXTURE
PLATE
WHITE
WIRE
FIXTURE
WIRE
6. After installing the fixture, caulk the upper 2/3s of the WALL PLATE to the mounting
surface. Leave the bottom 1/3 un-caulked to allow for drainage of any water that
might leak into the enclosure. The manufacturer recommends a non-drying exterior
caulking material. A good example is a clear silicone rubber sealant for exterior use.
7. RESTORE POWER AT THE CIRCUIT BREAKER. Turn on the wall switch.

TROUBLESHOOTING:

SYMPTOM POSSIBLE CAUSE
Lights do not come on at
Wall switch and/or circuit breaker is off.
all
Incorrect or loose wire connections.
Light from another light source, such as
Lights do not come on or
a street light or another light fixture, is
flicker
shining onto the photocell.
Component has malfunctioned.
Fixture may be installed in a shaded
Lights stay on throughout
area, such as under a porch or an eave,
the day (or stay on late into
and not enough light is shining onto
the day)
photocell during the daytime.
Fuse blows or circuit
Crossed wires or power wire is
breaker trips when light is
grounding out.
turned on
MOUNTING
BRACKET
BLACK (HOT)
SUPPLY WIRE
WHITE
(NEUTRAL)
SUPPLY
SUPPLY
WRE
GROUND
WRE
WIRE
NUT
Fig. 9
SOLUTION
Turn on wall switch and/or circuit
breaker.
Access outlet box and fix wire
connections.
Eliminate the light source or
move fixture to another location.
Call Altair Lighting support.
Relocate fixture to a well lit area.
Access outlet box and fix wire
connections.
Page 7
OUTLET
BOX