Controlling Combo Devices - GE Universal 33705 Manual De Instrucciones

Programming Your Remote
Did the device turn off?
• If YES, you have found a code for the
• If NO, continue to press and release the
Notes:
• The VOL button can be used to go backwards through
• The red indicator light will flash 2 times after testing
7. Use the remote to turn the device back on.
Test the buttons on the remote to see if the
device responds as you would expect. If the
buttons do not operate the device, return to
Step 2 and repeat this process to search for a
better code to operate the device.
8. Repeat this process for each device you wish
to control.

Controlling Combo Devices

Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/
VCR, etc.) will require you to set up two different Mode
buttons to control both parts of the Combo device.
For example, if you have a TV/DVD Combo, you might
need to set up one code under the TV button to
control the TV part AND a separate code (under any
other Mode button) to control the DVD part.
device. Press and release the same device
button you pressed in Step 3. This will
store the code in the remote. Go to Step 7.
VOL
button until the device turns off to
test the other 9 codes from Step 4.
Be sure to wait approximately 3 seconds
after each VOL
the device time to respond to the code.
When the device turns off, you have
found a code for your device. Press and
release the same device button pressed
in Step 3. This will store the code in the
remote. Go to Step 7.
each batch of 10 codes.
the first or last code in each batch of 10.
button press to allow
9