Troubleshooting - Skil JS314901 Manual Del Propietário

TROUBLESHOOTING

Problem Cause
Tool will not 1. The power cord is not plugged
start
2. The power source fuse or
3. Cord damaged.
4. Burned out switch.
Tool does not 1. Extension cord has insufficient
come up to
speed
2. Low house voltage.
Excessive 1. Blade is bent.
vibration
2. Blade not secure in blade
20
in.
circuit breaker tripped.
gauge or is too long.
holder.
Remedy
1. Plug tool into power source.
2. Replace the fuse or reset the tripped
circuit breaker. (If the product
repeatedly causes the circuit or fuse to
trip/blow, discontinue use immediately
and have it serviced by an Authorized
SKIL Service Center or Service
Station.)
3. Inspect the cord for damage. If
damaged, have the cord replaced by
an Authorized SKIL Service Center or
Service Station.
4. Have switch replaced by an Authorized
SKIL Service Center or Service
Station.
1. Replace with adequate extension cord
(Refer to the part of "EXTENSION
CORDS").
2. Contact your electric company.
1. Discard blade and use different blade.
2. See OPERATING INSTRUCTIONS
section, "Tool-free Blade Installation".