Pioneer SC-LX501 Manual De Instrucciones página 10

> Before start > Hookup
3/8˝
(10 mm)
1
1 Speaker cable, 2 Subwoofer cable
10
> Setup > Playback
2
> Part Names
in case of:
Pages 5 to 7
Connect 1234569:. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER jacks.
0 Apart from these connections, you can also connect
surround back speakers 7 and 8. However, you can
only output audio from one set of 78 or 9: at a time.
When you have connected both, you can select which
speakers to prioritize with "Speakers" (
Adjust.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" (

are using height speakers, set "Speaker Channels"
to "5.1.2 ch" in the setting screen. Select "7.1.2 ch"
if you have connected both surround back
speakers and height speakers.
Make sure the exposed wires of the speakers do not stick out of
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
P26) in the AV

P20) in Initial Setup. Note that if you