Homelite UT10640 Manual Del Operador página 26

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING THE GUIDE BAR AND
CHAIN
See Figures 34 - 43.
DANGER:
Never start the engine before installing the
guide bar, chain, clutch cover, and clutch drum.
Without all these parts in place, the clutch can
fly off or explode, exposing the user to possible
death or serious injury.
WARNING:
To avoid serious personal injury, read and
understand all the safety instructions in this
section.
 Always place the switch in the STOP "
tion before you work on the saw.
 Make sure the chain brake is not set by pulling
the chain brake lever/hand guard towards the
front handle to the run position.
NOTE: When replacing the guide bar and chain,
always use the specified bar and chain listed in
the Bar and Chain Combinations section later
in this manual.
 Wear gloves when handling the chain and bar.
These components are sharp and may contain
burrs.
 Remove the bar mounting nuts using the com-
bination wrench provided.
 Remove the clutch cover.
 Remove the bar and chain from the mounting
surface.
 Remove the old chain from the bar.
 Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.
 Place the chain drive links into the bar groove
as shown.
 Position the chain so there is a loop at the back
of the bar.
 Hold the chain in position on the bar and place
the loop around the sprocket.
MAINTENANCE
" posi-
 Fit the bar flush against the mounting surface
so that the bar studs are in the long slot of the
bar.
 Replace the clutch cover ensuring that the
adjusting pin in the clutch cover is in the bar
chain tensioning pin hole and that both bar
studs are securely in their respective holes in
the clutch cover.
NOTE: The adjusting pin may need to be slightly
repositioned with the chain tensioning screw
Page 26 — English
CutterS
Chain rotation
Chain drive linkS
Chain drive linkS
Fig. 37
Bar
groove
Fig. 38

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ut10660Ut10680

Tabla de contenido