Publicidad
Idiomas disponibles
Idiomas disponibles
SNAPPER
To
TROUBLESHOOTING
Problem
Pump
has following
problems:
failure
to produce
pressure,
erratic
pressure,
chattering,
loss of
pressure,
low water
volume.
Detergent
fails to mix with spray.
Engine runs good at no=load
but
"bogs"
when load is added.
Pressure
washer
stops during
operation.
Cause
I.
Low pressure spray tip installed.
2.
Water
inlet is blocked.
3.
Inadequate water supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water supply is over I00°E
7.
High pressure hose is blocked or
leaks.
8.
Gun leaks.
9.
Spray tip is obstructed.
10. Pump is faulty.
I.
Detergent
siphoning tube is not
submerged.
2.
Chemical filter is clogged or
cracked.
3.
Dirty in-line filter.
4.
High pressure spray tip installed.
Engine speed is too slow.
Out of gasoline.
Correction
I.
Replace spray tip with high
pressure
spray tip.
2.
Clear inlet.
3.
Provide adequate
water flow.
4.
Straighten
inlet hose, patch
leak.
5.
Check and clean inlet hose
strainer.
6.
Provide cooler
water
supply.
7.
Clear blocks in outlet
hose.
8.
Replace gun.
9.
Clean spray tip.
10. Contact
authorized
service facility.
I.
Insert detergent
siphoning
tube
into detergent.
2.
Clean or replace
filter/detergent
siphoning
tube.
3.
See "Check
In-Line Filter".
4.
Replace spray tip with low
pressure spray tip.
Move throttle
control
to FAST
position. If engine still "bogs down",
contact Briggs and Stratton service
facility.
Fill fuel tank.
Publicidad
