Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
3.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 2).
Handle
Handle
Supports
NOTE:
it may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4.
Insert"U'
bolt through hole on right side of handle
(viewing from handle side of unit) and attach plastic
knob.Tighten
knob by hand (Figure 3).
_L
5.
Insert carriage bolt through left side hole from outside
of unit and attach a plastic knob from inside of unit
(viewing unit from the handle side).Tighten
by hand
(Figure 3).
6.
Insert"]"
hook into second
from left slot in accessory
tray (Figure 4).
7.
Pinch chemical
hose and slide it into metal clip as
shown in Figure 5.
.
Tilt unit up by handle and attach
metal clip to rib on
center
underside
of accessory
tray (Figure 6). Slide
chemical
hose through
metal clip so that it is tight but
not kinked.
Add
Engine
Oil and
Fuel
• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations
and instructions.
CAUTION
" Refer to engine manual
for oil and fuel fill information.
. Damage
to equipment
resulting
from failure to follow this
instruction
will void warranty.
NOTE:
Check
oil often
during engine break-in.
Refer to
engine owner's
manual for recommendations.
Publicidad
