Publicidad
Idiomas disponibles
Idiomas disponibles
SNAPPER
T°
WARNING
, DO NOT touch
hot surfaces.
, Allow equipment
to cool before touching.
, The pressure
washer
must
be at least 5 feet from
structures
having combustible
walls and/or
other
combustible
materials.
. Keep at least 3 feet of clearance
on all sides of pressure
washer
for adequate
cooling, maintenance
and servicing.
. In the State of California
a spark attester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other
states
may have similar laws. Federal
laws apply on federal
lands. If you equip the
muffler with a spark attester,
it must be
maintained
in effective
working
order.
WARNING
. DO NOT wear
loose clothing, jewelry
or anything
that
may
be caught in the starter
or other
rotating
parts.
. Tie up long hair and remove
jewelry.
WARNING
I
. Always wear
eye protection
when
using this equipment
or in
vicinity of where
equipment
is in use.
WARNING
WHEN
ADJUSTING
OR NAKING
REPAIRSTOYOUR
PRESSURE
WASHER
" Disconnect
spark plug wire from spark
plug and place wire
where
it cannot
contact
spark plug.
CAUTION
DO NOT tamper
with governed
speed.
DO NOT operate
pressure
washer
above rated pressure.
CAUTION
DO NOT
secure
spray gun in open
position.
DO NOT
leave spray gun unattended
while machine
is
running.
NEVER use a spray gun which
does not have a trigger
lock or
trigger
guard
in place and in working
order.
Always
be certain
spray gun, nozzles
and accessories
are
correctly
attached.
CAUTION
DO NOT point spray gun at glass when in jet spray mode.
NEVER aim spray gun at plants.
CAUTION
If you have questions
about
intended
use, ask dealer
or
contact
Brigs
& Stratton
Power
Products.
NEVER operate
units with
broken
or missing parts,
or
without
protective
housing
or covers.
DO NOT
by-pass
any safety device
on this machine.
Before
starting
pressure
washer
in cold weather,
check all
parts
of the
equipment
to be sure ice has not formed
there.
NEVER move
machine
by pulling on high pressure
hose. Use
handle provided
on unit.
Check
fuel system
for leaks or signs of deterioration,
such as
chafed or spongy
hose,
loose or missing clamps,
or damaged
tank or cap. Correct
all defects
before
operating
pressure
washer.
This equipment
is designed
to be used with Brigs
& Stratton
Power
Products
authorized
parts
ONLY.
If equipment
is used
with parts
that
DO NOT
comply with minimum
specifications,
user assumes
all risks and liabilities.
Publicidad
