Blending - Silvercrest SHMS 300 A1 Instrucciones De Uso

You can also use the hand mixer without the mixing
stand 6. Especially with minor amounts of liquids
you are advised to use the hand mixer without the
mixing stand 6. Otherwise, the liquid may not be
completely captured and thus not mixed thoroughly.
Warning:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
Insert the plug 3 into a mains power socket.
9.
10. To set the mixer into motion, push the speed
switch 1 to the desired speed setting. You
can select between 5 speed settings or the
turbo button 0 (see section "Speed levels").
Warning:
Do not operate the mixer for longer than 10 minutes
in one session. After 10 minutes, allow the appliance
to rest until it has cooled itself down.
Note:
If ingredients become stuck to the side of the mixing
bowl 7 and they cannot be captured with the
kneading hooks r/ whisks e, switch the hand mixer
off. Remove the lid 9. Use the dough scraper t to
push them back into the middle of the mixing bowl 7.
Replace the lid 9. Switch the hand mixer back on.
11. To remove the bowl contents, switch the appli-
ance off. Pull the lid 9 to the side and remove
it. Press the release button for tilting 5, lift the
holder upwards and remove the mixing bowl 7
from the mixing stand 6.
Note:
In the case of larger amounts in the mixing bowl 7,
it is to be recommended that you first remove the
mixer from the holder.
12. Press the release button 4 to remove the hand
mixer and the ejection button q to release the
whisks e or the kneading hooks r.
Note:
For safety reasons, the whisks e or the dough
hooks r can only be released when the speed
switch 1 is in the position "0" or " " shows.

Blending

Warning:
Never use the blender w for hard foodstuffs such as:
coffee beans, ice cubes, sugar, cereals, chocolate,
raw/hard vegetables etc. They could cause serious
damage to the appliance.
Warning:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
1. Open the fixture for the blender 2 and hold the
safety cover 2 firmly.
Note:
The blender w can only be utilised when the whisks
e or the kneading hooks r are not installed.
2. Insert the blender w until it engages and then
twist it firmly tight.
3. To avoid overflows, the container used for blending
should only be filled to 2/3rds of its capacity.
Select a sufficiently large container.
Tips:
• To ensure an effective blending of the ingredients,
the foodstuffs to be processed should cover at
least the lower section of the blender w.
• First switch the hand mixer on when the blender w
has been inserted into the ingredients to be
blended.
- 29 -