Front And Rear Rails - Delta 36-5000 Manual De Instrucciones

EXTENSION WINGS
For Models with Two Extension
Wings and a Wood Extension Table
1. Attach the left and right side extension
wings (A) to the table using three 5/16-
18 x 7/8" hex head screws for each
wing.
2. Make sure the top edges of the wings
are flush with the top of the table and
tighten all six screws.
3. Proceed to rail assembly.

FRONT AND REAR RAILS

1. Attach the front rail (A) (2" X 2" X 57" for
the 30" rip capacity models), (2" X 2" X
79" for the 52" rip capacity models), to
the saw table and extension wings using
5/16-18 x 1 1/8inch flat head screws.
Align the holes in the rail with the holes
in the table and extension wings.
2. Use supplied rail alignment gage (B) to
ensure the rail is the proper distance
from the top of the table at each side of
the cast iron table. (fig 6) Then use the
alignment gage to set the same proper
distance for the extension wings.
3. Align the rear rail to the holes in the
rear of the saw table and extension
wings. Attach the rear rail to the saw
table using two 5/16-18 x 7/8 Hex head
screws.
4. Attach the rear rail to the extension
wings using 5/16-18 X 7/8 inch hex head
screws and Hex flange nuts.
5. Use supplied rail alignment gage (B) to
ensure the rail is the proper distance
from the top of the table at each side of
the cast iron table. (fig 6) Then use the
alignment gage to set the same proper
distance for the extension wings.
ASSEMBLY
(continued)
1
IN C H
0
A
Gauge
Back
FIGURE 6
13
1 2
1 1
1 0
9
8
7
6
5
4
3
2
FIGURE 5
Table
Table
Rail
Rail
Front
Gauge