Tabla de contenido
Publicidad
Settings
Display Rev
=
Display
=
DMX Fail
=
DimmerCurve
=
Pan Rev
=
Tilt Rev
=
Pan Angle
=
Feedback
=
Fan Set
=
Mov Blackout
=
Test
=
Reset
=
NETWORK SETTINGS (Network Setting)
Pressing the MODE button will take you to the selection menu for system settings. Using the arrow buttons, select the menu item "Network Setting"
(dark background) and confirm by pressing ENTER. You will then be taken to the sub-menu to set the following sub-menu items (select the sub-
menu items with +, -, set with ENTER, +, -, ENTER):
System Settings
DMX Address
001
Mode
DMX 111CH
Settings
Network Setting
System Info
Flip Display
ON
OFF
Display lighting
ON
OFF
Operation status with DMX
Hold
signal interruption
Auto
Blackout
Dimmer Curve
Linear
Exp
Log
S-Curve
Pan Reverse
ON
OFF
Tilt Reverse
ON
OFF
Pan Angle
630
540
position correction
ON
OFF
fan control
Regular
Silent
Automatic blackout during
ON
head movement
OFF
Function test
ON
OFF
Reset
Pan&Tilt
= Rotation of the display by 180° (overhead installation)
= no rotation of the display
= permanently on
= deactivation after approx. 20 seconds of inactivity
= last command is held
= activates the AUTO mode
= activates Blackout
= The light intensity increases linearly with the DMX value.
= Adjustment of the light intensity is finer in the lower DMX value
range and coarser in the upper DMX value range.
= Adjustment of the light intensity is coarser in the lower DMX value
range and finer in the upper DMX value range.
= Adjustment of the light intensity is finer in the lower and upper DMX
value ranges and coarser in the middle DMX value range.
= Reversal of the Pan direction
= no reversal of the Pan direction
= Reversal of the Tilt direction
= no reversal of the Tilt direction
= Pan angle 630°
= Pan angle 540°
= activates automatic position correction
= deactivates automatic position correction
= maximum brightness at normal fan function
= if necessary, reduced brightness at very silent fan function
= Blackout during head movement
= no blackout during head movement
= step-by-step function test of LEDs and motors (Pan, Tilt,)
= stops the function test
= Resetting of the Pan & Tilt motors
19
Publicidad
Tabla de contenido
