4. Push the unwanted oil out of the air filter while in the
plastic bag.
To lubricate the gear housing
•
Use Husqvarna special grease. Speak to your
servicing dealer for more information about
recommended grease.
•
Add the grease through the cap on the gear housing.
CAUTION: Do not fill the gear housing fully.
Troubleshooting
The engine does not start
Problem
Starter pawls
Fuel tank
Carburetor
994 - 001 - 25.02.2019
Troubleshooting
Possible cause
The starter pawls cannot
move freely.
Incorrect fuel type.
Incorrect idle speed.
To clean and lubricate the blades
1. Clean the blades from unwanted materials before
and after you use the product.
2. Lubricate the blades before long periods of storage.
Speak to your servicing dealer for more information
about recommended lubricants.
To examine the blades
1. Remove the cap on the gear housing.
2. Make sure that the blades move freely. Put the
combination wrench in the gear housing and turn
clockwise and counterclockwise.
3. Examine the edges of the blades for damages and
deformation.
4. Use a file to remove burrs on the blades.
Recommended step
Adjust or replace the starter pawls.
Clean around the starter pawls.
Speak to an approved servicing dealer.
Drain it and use correct fuel.
Adjust the idle speed.
13