Tabla de contenido
Publicidad
ENGLISH
14
Technical Data
Angle Grinder
Art. No
Service connection
Rated input
No-load speed
Grinding disk diameter max.
Grinding disk thickness max.
Cutting disk thickness min. / max.
Grinding surface diameter max.
hole diameter
Thread of work spindle
Weight
Noise details
Sound pressure level L
Sound power level L
Measured according to EN 60745; Uncertainty K = 3 dB (A)
Wear ear protectors!
Vibration details
Vibration total values (triaxial vector sum) determined according to EN 60745:
Surface grinding: Vibration emission value a
Disk sanding: Vibration emission value a
Uncertainty K = 1,5 m/s
For other applications, e.g. Abrasive Cutting-Off Operations or Wire Brushing other vibration values could
occur.
WARNING: The vibration emission level will vary because of the ways in which a power tool can be used and
may increase above the level given in this information sheet.
The vibration emission level may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
An accurate estimate of the vibratory load should also take into account the times when the tool is shut down
or when it is running but not actually in use. This may significantly reduce the vibratory load over the total
working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organisation of work patterns.
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
Persons over 18 years of age can only work on the
appliance. An exception includes youngsters trained
in order to reach knowledge under supervision
of the trainer during occupational education.
pA
WA
h, DS
2
Read and understand the operating
instructions before using the
appliance. Familiarise with the
h, SG
In case of any doubts about connection and operati-
on refer please to our customer center
Specified Conditions Of Use
The angle grinder is used for grinding and cutting
metal, stone and ceramic materials, as well as for
sanding.
Use the cutting guard from the accessories range for
cutting application.
Please refer to the instructions supplied by the acces-
sory manufacturer.
WS 125-900 WS 125-1150 E
58107
230 V ~ 50 Hz
230 V ~ 50 Hz
900 W
12000 min
3000 - 11000 min
-1
125 mm
125 mm
6,3 mm
2,7 / 3,3 mm
2,7 / 3,3 mm
125 mm
125 mm
22,23 mm
22,23 mm
M14
1,7 kg
88,1 dB(A)
88,4 dB(A)
99,1 dB(A)
99,4 dB(A)
4,948 m/s²
7,162 m/s²
58108
1150 W
-1
6,3 mm
M14
2,4 kg
Publicidad
Tabla de contenido
