Cassette Recorder; Recording - Philips AZ 2765 Manual Del Usario

CASSETTE RECORDER

PLAYING A CASSETTE
1. Press POWER to on position.
2. Press TAPE source button.
– The TAPE indicator lights up.
3. Press STOP•EJECT 9/ to open the cassette holder and
insert a cassette.
4. Press the cassette holder shut.
5. Press PLAY 2 to start playback.
6. Adjust the sound using the VOLUME and DBB.
7. To pause playback press PAUSE ;. To resume, press the key
again.
8. By pressing 5 or 6,fast winding of the tape is possible in
both directions.To stop fast winding, press STOP•EJECT 9/.
9. To stop the tape, press STOP•EJECT 9/.
– The keys are automatically released at the end of the tape,
except if PAUSE ; has been activated.
10. Press POWER to off position to switch off the set.
– The TAPE indicator goes out.
Continuous Playback
1. Repeat steps 1 - 4 above, but load both decks. Press PLAY 2
on deck 2 and deck 2 will start.
2. Press PAUSE ; on deck 1 and then PLAY 2. As soon as
deck 2 stops (end of tape or STOP•EJECT 9/ pressed),
PAUSE ; on deck 1 is released and deck 1 will start
playback.
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• Recording is only possible on deck 1.
• This deck is not suitable for recording on CHROME (IEC
METAL (IEC IV) type cassettes. For recording, use NORMAL
type cassettes (IEC I) on which the tabs have not been broken.
• The best recording level is set automatically. Altering the
VOLUME and DBB controls will not affect the recording in
progress.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
• To protect a tape from accidental erasure, have the tape in
front of you and break out the left tab.
Recording on this side is no longer possible. To record over this
side again, cover the tabs with a piece of adhesive tape.
AZ 2765 /17

RECORDING

CD
TU NE R
STO P
SEA RC H
II) or
15
page
TA PE
PRO G
PLA Y/P AU SE
B
15