Operation Without The Remote Control Unit; Care And Cleaning; Air Filter - Argo AWIAS7DC Instrucciones De Uso

3742540532-U-AWIAS7-BS9DC
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired mode
(COOL or HEAT).
EG
NOTE
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION selector with a pen until the OPERATION
lamp is turned off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.

CARE AND CLEANING

WARNING
Maintenance operations must be carried out by specially
l
trained personnel.
For safety, be sure to turn the air conditioner off and also
l
to disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will
l
damage the internal components and cause an electric
shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
When cleaning the grille, be careful not to force the vanes
out of place.
CAUTION
Never use solvents, or harsh chemicals when cleaning the
l
indoor unit. Do not wipe the plastic casing using very hot
water.
Some metal edges and the vanes are sharp and may
l
cause injury if handled improperly; be especially careful
when you clean these parts.
The internal coil and other components of the outdoor
l
unit must be cleaned every year. Consult your dealer or
service centre.
20-07-2015 8:49 Pagina 10

AIR FILTER

The filter behind the front panel should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
1. Grasp both ends of the front panel and pull it towards you
2. Push the filter up slightly, and then pull it down. Clean the
HOW TO REPLACE THE FILTER
O P E R AT I O N
selector
1. With the «FRONT» mark facing you (if present), slide the
2. After installing the filter, close the front panel .
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
10
Front panel
and up.
air filter.
Insert into the groove on the unit
filter up into the unit and insert it in its place.
Air filter
Front panel
Air filter