Delivery Scope And Transport Inspection; Unpacking; Disposal Of The Packaging; Setup - CASO DESIGN MG20 CERAMIC menu Manual Del Usuario

13.2 Delivery scope and transport inspection

As a rule, the device is delivered with the following components:
 Microwave & Grill MG20CERAMIC menu
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

13.3 Unpacking

To unpack the device, proceed as follows: Remove the device out of the carton and remove
the packaging material. Remove the accessories located in the cooking chamber and
remove the packaging material. Remove the red coloured safety adhesive strip on the floor
of the cooking chamber. Remove the blue protective film on the device itself.
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
► Please don't remove the protective film from the inside of the door (if equipped), since
this makes the cleaning of the device easier.

13.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled. Returning the packaging back to the material loop saves
raw materials and reduces the quantities of accumulated waste. Take any packaging
materials that are no longer required to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.

13.5 Setup

13.5.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.
 Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
Please note
Please note
Please note
 Operating Instructions  metal rack
51