Conglom QK23 Manual Del Usuario página 10

Installation (continued)
INSTALLING THE SINK
NOTE:
Install the faucet according to the manufacturer's instructions before
completing this step. Install the strainer accordingly to the instructions on
page 11 before completing this step.
- Attach the topmount clips (E) to the clip brackets until they
snap in place .
- Using a screw driver, extend the clips such that they clear the
counter when installed .
- Rotate the clips so that they are parallel with the sink bowl on
all sides .
- Apply silicone sealant (not included) around the underside of
the flange of the sink (A) on all four sides or all around the top
edge of the cutout in the countertop .
- Carefully lower the sink (A) into the counter, ensuring it is
centered and parallel with the front of the counter .
- Rotate the clips into position and tighten them down to the
counter progressively (see tightening sequence) until the sink
flange is flush with the counter. Do not over-tighten the clips
as that can damage the brackets . Check the alignment as you
tighten so that the sink (A) is centered and parallel .
NOTE:
If the flange is not flush with the counter, use a heavy weight or clamp
from above to press the flange down until the sealant sets.
- When finished, wipe away any excess sealant and allow it to
set before proceeding with the rest of the installation .
QK23
A
Clip
Bracket
E
A
A
Silicone
Sealant
E
Counter
2
10
12
Location
3
of clip
Tightening sequence for clips
10
A
Counter
Thickness
Clip
Bracket
A
8 6 4
11
9
5 7 1