Hitachi CG 25EUAP Manual De Instrucciones página 10

English
CAUTION
● To avoid the risk of burn injury, allow the
engine to cool thoroughly before changing
the engine oil.
● To prevent breakdown, ensure that no sand
or dirt gets into the oil tank while refueling.
Fuel
WARNING
○ Provide good ventilation, when fueling or
handling fuel.
○ Fuel contains highly fl ammable and it is possible
to get the serious personal injury when inhaling
or spilling on your body. Always pay attention
when handling fuel. Always have good ventilation
when handling fuel inside building.
○ Always use branded 89 octane unleaded
gasoline.
○ Do not use a mixture of gasoline and engine
oil as this may lead to starter failure or power
reduction.
Fueling
WARNING
● Always shut off the engine and let it cool for
a few minutes before refueling.
Do not smoke or bring fl ames or sparks near
the fueling site.
● Slowly open the fuel tank, when fi lling up
with fuel, so that possible over-pressure
disappears.
● Tighten the fuel cap carefully, after fueling.
● Always move the trimmer at least 10 ft (3 m)
from the fueling area before starting.
● Always wash any spilled fuel from clothing
immediately with soap.
● Be sure to check for any fuel leakage after
refueling.
● Before fueling, in order to remove static
electricity from the main body, the fuel
container and the operator, please touch the
ground that is slightly damp.
Before fueling, clean the tank cap area carefully, to
ensure that no dirt falls into the tank.
Starting
WARNING
● Before starting the tool, ensure that the
cutting attachment is not touching any
objects or the ground. Otherwise, the cutting
attachment may unexpectedly rotate and
cause an injury.
10
● Ensure that the cutting attachment does not
rotate while the engine is idling. If it does
rotate, adjust the idle speed according to the
instructions in "Idle speed adjustment" in
the "MAINTENANCE" section. If the cutting
attachment still rotates after this adjustment,
immediately stop the engine and cease use,
then bring the tool to the nearest Hitachi
Authorized Service Center.
1. Starting the cold engine
(1) Set ignition switch (10) to ON position. (Fig. 8)
(2) Push priming bulb (11) several times so that fuel
fl ows through return pipe (12). (Fig. 9)
11
(3) Set choke lever (13) to START position (closed)
(A). (Fig. 10)
13
START
RUN
(4) Pull recoil starter briskly, taking care to keep the
handle in your grasp and not allowing it to snap
back. (Fig. 11)
10
Fig. 8
12
Fig. 9
Fig. 10